Replies to This Discussion

Permalink Reply by scott peterson on April 1, 2014 at 5:12am

Should be interesting.........shock gobbling to the sounds of big diesel engines....hahah

Permalink Reply by GW3 on April 1, 2014 at 5:41am

Fritz well

Attachments:

• image.jpg, 1.2 MB

Permalink Reply by Jeffrey Stoll on April 2, 2014 at 12:17pm

They have the vertical hole done.  They are bringing in the big rig to start the laterals/horizontal drilling soon.  Can anyone explain a subsurface agreement of some sort that gives permission to drill outside the unit and then back in to the unit? They supposedly can drill outside the unit just not produce outside the unit. They are requesting this because they want to also go SE off the Fritz pad and need permission to do so.

Permalink Reply by Philip Brutz on April 2, 2014 at 2:48pm

The unit starts at the entry point in the target shale layer, not at the surface drill pad.  I have seen a few plat maps where the drill pad is outside of the unit.  Has anyone seen the plat map for this well?

Permalink Reply by Jeffrey Stoll on April 3, 2014 at 12:31am

That could be the reason then.  The well pad is on the SE edge of the fritz unit drilling to the NW.  They want to use the same well pad to drill a new unit to the SE.  I think there is possibly some distance between the 2 units of a few hundred feet

Permalink Reply by Philip Brutz on April 3, 2014 at 1:15am

This is the plat map for the Clark well:http://www.dnr.state.oh.us/mineral/oil/MRMImages/17/1/232653.pdf

The well pad is outside of the drilling unit. 

Permalink Reply by scott peterson on April 3, 2014 at 2:28am

What is the length of this unit Phil. Cant read it on my phone & not at my computer, just curious.

Permalink Reply by Philip Brutz on April 3, 2014 at 3:01am

The Clark 580007 is 6547' long.

Permalink Reply by scott peterson on April 3, 2014 at 3:04am

thx

Permalink Reply by Philip Brutz on April 3, 2014 at 4:47am

I used the ODNR Oil and Gas well viewer:https://gis.ohiodnr.gov/website/dog/oilgasviewer/

Zoom in on the well that you want information about, then click on the identify button, then click on the Well summary report link. If the plat map is available there be a link to it at the bottom of the Well summary report.  The plat maps are not yet available for the Fritz well.

Permalink Reply by Walt on April 7, 2014 at 4:51am

I just received a letter from TGS wanting permission to perform seismic testing under the freeport 3d south project. Stated they will be doing testing later this year.  I was wondering if any one else has received a similiar letter.  I am in Millwood township on Putney Ridge.

 

Regards

Permalink Reply by evan on April 7, 2014 at 5:13am

Yes I just talked to them Friday. Not sure what it all is about since I'm in a unit and drilled already. I'm still going to look into it some. I to am in Millwood. Close to putney

• ‹ Previous
• 1
• …
• 5
• 6
• 7
• 8
• 9
• …
• 105
• Next ›
• Page