Replies to This Discussion

Permalink Reply by Albert Russell on October 30, 2015 at 9:37am

Looks like they are putting in pipe line in to tie in all the pads to market gas.

Permalink Reply by Albert Russell on November 3, 2015 at 2:00pm

What time frame are we looking at for the winesburg pad to be put in production?

Permalink Reply by James M Stephens on November 9, 2015 at 7:37am

Both the Thompson and Conway pads have drill rigs on them. Drove by both of them yesterday morning.

Permalink Reply by Albert Russell on November 17, 2015 at 1:37pm

Gulfport appears to be moving forward with work on Pugh ridge, edge pad is now being fracked.

Permalink Reply by Albert Russell on December 6, 2015 at 3:03pm

I heard that Gulfport is going to put one more pad on Pugh ridge. Does anyone know where it might be located?

Permalink Reply by James M Stephens on December 7, 2015 at 4:18am

I hope that it is between the Lepley and Thomson pads, there are quite a few people esat of us that signed up when we did that have not had any activity associated with their property, only a very small piece of ours in the Lepley unit.

Permalink Reply by Albert Russell on December 21, 2015 at 5:27am

Any information on when the edge will be put into production?

Permalink Reply by James M Stephens on December 21, 2015 at 5:43am

I do not know about the Edge Pad. The Lepley well is scheduled to go to market in March, which will make division orders and royalty payments around June or so. All this is not cast in stone and could vary, the price of gas being in the toilet could delay this as well.

Permalink Reply by James M Stephens on December 21, 2015 at 5:46am

A new permit was finished last week for the "George" Well Pad. It originates just north of 148 near the big strip mine and runs southeast to Pugh Ridge.

Permalink Reply by MrMojoRisin on December 21, 2015 at 9:10am

I think this is the one we'll be in.... While I'm excited to be in a unit, I was hoping that we'd make it past the renewal deadline for the extra payday. Looks like they drug this one over the line with only a couple days to spare.

An issued permit is enough to be considered "held by production", correct?

Permalink Reply by James M Stephens on December 21, 2015 at 10:21am

Yes

Permalink Reply by James M Stephens on December 21, 2015 at 10:22am

There isn't a Platt drawing yet, should be one soon and it will list how many acres you have in the unit.

• ‹ Previous
• 1
• …
• 6
• 7
• 8
• 9
• Next ›
• Page