Replies to This Discussion

Permalink Reply by Mat B on February 8, 2011 at 3:51am

New pad will be on Rt 208 between Shippenville and Fryburg.  Drilling is going to be for the Utica Shale

Permalink Reply by DJF on February 16, 2011 at 7:12am

There is a pad under preparation on a farm near there which is clearly visible from the highway, however the seam to be drilled for isn't known.

 

Permalink Reply by matthew h mcsparren on February 28, 2011 at 1:01pm

Looked at the DEP web site today appears that the well on rt. 208 in the Marbel area is being drilled by Pa. general energy from Warren. Well is not listed as a Marcellus but is listed for a lateral, looks like well is to be drilled to a deph of 5400 ft. Is that deep enough for a utica well?

Permalink Reply by Mat B on March 1, 2011 at 6:11am

I was told today they are about finished drilling this well and it is a Utica well.

Permalink Reply by matthew h mcsparren on March 15, 2011 at 11:30pm

any info. on the well on rt. 208? heard the drilling rig has moved out.

Permalink Reply by DJF on March 23, 2011 at 4:59am

They hit a ton of salt water in the shale between the Marcellus and the Utica and DEP shut them down. 

Permalink Reply by Mat B on March 23, 2011 at 5:07am

I heard it was a dry hole, they didn't drill down far enough only 5200 ft.  All kinds of rumors circulating about this.  Is this a fact?

Permalink Reply by DJF on March 23, 2011 at 5:24am

The salt water comment came from a DEP rep.

Permalink Reply by Mat B on March 23, 2011 at 5:31am

thanks

Permalink Reply by matthew h mcsparren on June 7, 2011 at 11:24am

Has a rig moved back to the well near Marble?

Permalink Reply by RichR on June 8, 2011 at 4:49am

This is what was in the Clarion News last week:

"DEP issued a permit to Pennsylvania General Energy for the Ziegler 2527 well on Feb. 7. Drilling began on the site just off State Route 208 in the southern end of Washington Township a week later.

But drilling was stopped and the well abandoned and sealed, according to DEP spokesperson Freda Tarbell, when drillers ran into excessive amounts of water in the Onandaga formation, just below the Marcellus and above the Oriskany."

Permalink Reply by matthew h mcsparren on June 9, 2011 at 11:28pm

Well was sealed, not pluged. A working rig is on site. Could they plug the well back to the Marcellus, and make a working Marcellus well ?

• ‹ Previous
• 1
• 2
• Next ›
• Page